"I boost the volume in my pedal mods by simply inserting a low gain, flat frequency response amplifier stage just before the volume pot. Normally this consists of a single op-amp circuit. Gives massive boost, works and treat and doesn't change the characteristic of the pedal.
Mine use surface mount components and a PCB less than an inch square, but I've successfully built them on stripboard using through hole parts and still fitted them into a Boss housing."
Da li je neko radio u ovom pravcu?
Meni je konkretno palo na pamet da ubacim LPB-1 pre lvl pot-a, ali ne znam kakve ce se to odraziti na citav sistem.
Ubaceni LPB bi dobijao napajanje sa maticnog PCB-a. Signal sa maticnog PCB-a ispred lvl pot-a ide na LPB-ulaz i onda sa LPB-izlaza nazad na lvl pot.
Deluje jednostavno
Da ne smuknem nesto u ovoj jednostavnosti
?Kako god,
PS Kako bi izgledala sema njegovog resenja?
